Operation Of The Machine; Inserting The Needle - VETRON 5400 Instruction Manual

1
2
CAUTION! RISK OF INJURY!
Push the X-button at the machine head, the red light illuminates showing the active
"BLOCKED MODE" or turn the machine o , before inserting the needle. Failure to
comply produces a risk of injury in case of an unintentional machine operation.
INFO
Only use needles from the system intended for the machine.
(Needle lsystem 134-35)
01. Push the X-button at the machine head, the red light illuminates showing
the active "BLOCKED MODE", or turn the machine o .
02. Loosen the screw
03. Push the needle
on the needle is to the right side.
04. Tighten the screw
05. Push the X-button or switch the machine on again and follow the instructions
displayed in the control panel.
NOTICE:
Before activating the machine by the X-button make sure to remove sewing material or
other items below the sewing feet if necessary and follow the instructions displayed on
the control panel.

03. OPERATION OF THE MACHINE

1 .
fully in until it stop. Make sure that the groove
2
1 again.
VETRON 5400 - CYLINDER ARM MACHINE - INSTRUCTION BOOK

01. INSERTING THE NEEDLE

3
3
07/2020
21