4.4
Cable Management System Installation
Follow instructions per document # 07233.
Note that concrete anchors are provided with installation kit.
4.5
Wiring
4.5.1 General Guidelines
Check utility configuration tag on GSE SVS100 to make sure that rated input voltage
matches local utility voltage. See Table 4-1 for details.
See Table 4-1 for Input/Output parameters.
4.5.2 Ground Wire
Green or green with a yellow stripe and attached to the compression lug provided.
4.5.3 Charging Cables
To avoid shock hazard, only install cables approved by PosiCharge for outdoor use.
4.5.4 Chassis Ground
See Table 4-1 for wiring size (AWG) and additional information.
Use THHN or similar type, 600V, 90° C, suitable for conduit use.
Use copper conductors only.
Minimum ground wire size is listed. Refer to local electrical codes for reference.
4.5.5 Grounding
GSE SVS100 must be connected to an equipment-grounding conductor routed with the
circuit conductors. Connections must comply with all local codes and ordinances.
The GSE SVS100 must be grounded in accordance with the Facilities Utility grounding
method.
See Table 4-1 for minimum ground wire size.
4.5.6 Hardware
Manufacturer does not supply all external mounting hardware. User-supplied hardware may be
needed to complete the installation.
23435-W-03-01
SVS100 Installation, Operation and Maintenance Manual
12
Webasto Charging Systems, Inc.