Wiring; General Guidelines; Ground Wire; Charging Cables / Cable Management System - Webasto SVS300 Installation, Operation And Maintenance Manual

SVS-200
4.2

Wiring

4.2.1 General Guidelines

 Check utility configuration tag on SVS-300 to make sure that rated input voltage matches
local utility voltage. See Table 4-1 for details.
 See Table 4-1 for Input/Output parameters.

4.2.2 Ground Wire

 Green or green with a yellow stripe and attached to the compression lug provided.

4.2.3 Charging Cables / Cable Management System

 To avoid shock hazard, only install cables approved by PosiCharge
DANGER

4.2.4 Chassis Ground

 See Table 4-1 for wiring size (AWG) and additional information.
 Use THHN or similar type, 600V, 90° C, suitable for conduit use.
 Use copper conductors only.

Minimum ground wire size is listed. Refer to local electrical codes for reference.

4.2.5 Grounding

 SVS-300 must be connected to an equipment-grounding conductor routed with the circuit
conductors. Connections must comply with all local codes and ordinances.
 The SVS-300 must be grounded in accordance with the Facilities Utility grounding method.
 See Table 4-1 for minimum ground wire size.

4.2.6 Hardware

Manufacturer does not supply all external mounting hardware. User-supplied hardware may be
needed to complete the installation.
20153-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
CABLES CARRY HIGH POWER/CURRENT
Damaged Cables and/or connectors can be a serious safety hazard.
Cables must be secured with an Approved Cable Management System.
Cables are to be kept off the floor.
Failure to use a Cable Management System may invalidate Product
Warranty.
Installation, Operation and Maintenance
7
™
for indoor use.
Webasto Charging Systems, Inc.