Table of Contents
Advertisement
5.10.1
Clear Backup Memory
The clear battery backed RAM Data screens (See Figure 5- 11) allow the user to clear the
battery-backed charger memory. This memory contains the charge event log, the fault event
log, and the charger configuration parameters.
In the "Clear RAM Data?" screen, use the UP and DOWN arrows to choose "OK" or "Cancel".
Press ENTER while "OK" is displayed to clear the memory; Press ENTER while "CANCEL" is
displayed or press "CLEAR" to cancel clearing the memory.
Clear Backup Memory
CLEAR
Clear stored data?
Cancel
5.10.2 External Light Configuration
The External Light Configuration Menu (See Figure 5- 12) allows the user two modes of
operation:
- The Selector Mode (default=Disable) when Enabled it is used to provide the capability to
command the Charger, via the diagnostic port, ie. SOC for Truck Selector, the external system
commands the Charger to illuminate the green light and extinguish the red light for the trucks
that are ready for use.
- When Selector Mode is Disable it enables the use to set 3 external lights that can be
configured to monitor any of 5 states of Charger operation.
5.10.2.1
Selector Mode
From the "External Light Configuration" screen:
Press <enter> to display the Selector Mode setting. (Default is set to Disable)
Press <enter> to select Enable / Disable Selector Mode setting.
Use the <up> and <down> buttons to choose the selector mode setting.
Press <clear> to exit
23435-W-03-01
SVS100 Installation, Operation and Maintenance Manual
CLEAR
ENTER
Figure 5- 11 Clear Backup Memory Menu
34
Charger Configuration
Clear stored data?
OK
ENTER
Clearing Backup Mem
Please wait ...
after count to 100%
Set Date and Time
Webasto Charging Systems, Inc.
0%
Advertisement
Table of Contents
