Upgrade system firmware
1.
Download the latest firmware file from
thermofisher.com
2.
Unzip and transfer the firmware upgrade
files to a USB storage device.
3.
Insert the USB storage device into a USB
port on the instrument.
a.
b.
4.
Press Settings /
update. The instrument will search for the
update files in the USB storage device.
5.
Select Update. The instrument will
automatically install the new software.
Installation takes 1–2 minutes. The
instrument reboots after software
installation is complete.
Important: do not power off the
instrument during software installation.
6.
After installation is comple, remove the the
USB storage device.
7.
Switch the instrument off, then after a few
seconds, switch the instrument on again.
8.
Verify that the updated software is
installed by pressing Settings /
select About instrument.
E-Gel
Power Snap Electrophoresis System User Guide
™
to your PC.
Use the port located at the back of the
E-Gel
Power Snap Electrophoresis
™
Device (A) to upgrade the
electrophoresis unit.
Use the port located at the front of the
E-Gel
Power Snap Camera (B) to
™
upgrade the camera.
, then select Software
A
B
, then
39