Safety; Before Starting - Thermo Scientific invitrogen E-Gel G8121ST User Manual

Safety

Before Before you begin using this product, or any installation or service operation, please read the
following safety information. Attention to these warnings will help prevent personal injuries and
starting
damage to the products.
It is your responsibility to use the product in an appropriate manner. This product is designed for
use solely in laboratory environments, and must not be used in any way that may cause personal
injury or property damage.
You are responsible if the product is used for any intention other than its designated purpose or in
disregard of Thermo Fisher Scientific instructions. Thermo Fisher Scientific shall assume no
responsibility for such use of the product.
The product is used for its designated purpose if it is used in accordance with its product
documentation and within its performance limits.
Using the product requires technical skills and a basic knowledge of English. It is therefore
essential that only skilled and specialized staff or thoroughly trained personnel with the required
skills be allowed to use the product.
Keep the basic safety instructions and the product documentation in a safe place and pass them on
to the subsequent users.
Applicable local or national safety regulations and rules for the prevention of accidents must be
observed in all work performed.
Operation of the E-Gel
• Indoor use.
Altitude below 2000 meters.
•
Temperature range: 5 to 30ºC.
•
• Maximum relative humidity: 80% (maxiumum relative humidity 80% for temperatures up to
31ºC, decreasing linearly to 50% relative humidity at 40ºC).
Installation categories (over voltage categories) II; Pollution degree 2
•
Mains supply voltage fluctuations not to exceed 10% of the nominal voltage (100–240 V, 50/60
•
Hz, 1.3 A).
Mains plug is a disconnect device and must be easily accessible.
•
Do not attempt to open the E-Gel
•
warranty, the E-Gel
Thermo Fisher Scientific.
The protection provided by the equipment may be impaired if the equipment is used in a
•
manner not specified by Thermo Fisher Scientific.
• The device must be connected to a mains socket outlet with protective earthing connections.
Ventilation requirements: room ventilation.
•
56
Power Snap Electrophoresis System is subject to the following conditions:
™
Power Snap Electrophoresis System. To honor the
™
Power Snap Electrophoresis System can only be opened and serviced by
™
Appendix H
E-Gel Power Snap Electrophoresis System User Guide
™