Table of Contents
Advertisement
Installation
4.3
Armstops
Fit end stops between the lift arms and the rear
member of the vehicle floor. The left and right end
stops must be reached at the same time, as high up
the lift arm as possible. Installation must take place
against the vehicle body.
m
WARNING!
It is not permitted to perform welding in the lift
arm. Installation must take place against the
vehicle body.
4.4
Sealing strip (horizontal)
The track is fitted using the self-tapping screws
provided.
1. Mark where to drill holes for the self-tapping
screws.
2. Drill holes (Ø 7.2 mm) for the screws.
3. Fit the horizontal stop strip (steel or aluminium).
4. Fit the rubber strip to the track.
4.5
Sealing strip (vertical)
1. Fit the tracks with countersunk screws, rivets or
by spot welding.
2. Fit the rubber strip to the track.
3. Secure the rubber strips by swaging the tracks
together at the bottom.
NOTE!
To fit an upper edge seal, create a 45° mitre
against the vertical strips.
28
Z 1500/2000-135/155/175
Figure 46. Fit end stops between the lift arms
and the rear member of the vehicle floor
Figure 47. Installing a sealing strip
www.zepro.com
Advertisement
Table of Contents
