Table of Contents
Advertisement
Safety rules
Z 1500/2000-135/155/175
3.4
Rear beam cut-outs
It is often necessary to make cut-outs in the rear beam to make room for the platform arms when the platform
is in the top position. Cut-out size is determined by the calculated integration dimension 'A'; see figure below.
1. Measure and mark the location and depth of the cut-outs on the rear beam. Centre the two rear beam cut-
outs, i.e. the cut-outs must be equidistant from the beam's centre point.
2. Cut along the markings.
3. Grind away any burrs or sharp edges.
A max
245
245
994
Figure 17. Z 1500/2000
14
www.zepro.com
Advertisement
Table of Contents
