Table of Contents
Advertisement
Connection
6
Connection
6.1
Cable grommet
6.1.1
Before connection
1. Disconnect the cable grommet's protective cover, which is secured with three screws; see Figure 74.
2. Loosen the five screws on the cable grommet, see Figure 75. Cables can now be installed/removed/
adjusted in the grommet. The cable should be installed together with existing cabling using cable ties. En-
sure the length of the cable is sufficient. The outer casing should be stripped back 350 mm. See Figure 76.
6.1.2
After connection
1. Tighten the five screws once all cables are suitably located in the cable grommet, see Figure 75.
Tightening torque: 5 Nm.
2. Install the cable grommet's protective cover with the three bolts provided, see Figure 74.
Tightening torque: 8 Nm.
Figure 74. Fasten the cable grommet's pro-
tective cover with three screws
Figure 76. The outer casing of cables should be stripped 350 mm.
42
Z 1500/2000-135/155/175
Figure 75. Cable grommet's five screws
350 mm.
www.zepro.com
Advertisement
Table of Contents
