Table of Contents
Advertisement
Installation
4.2
Platform
1. Check that all included components are clean,
clean where necessary.
2. Lubricate the metal bushings on the upper bear-
ing of the arms. Make sure the small holes on
the inside of the bushings are filled with grease.
See Figure 32.
Use LE lubricant 4622 or the equivalent.
!
IMPORTANT
Carefully lubricate the metal bushings on the upper
bearing of the arms. Make sure the small holes
are filled with grease. After installing the platform,
grease all bearings including the two regular grease
nipples; see section "9 Lubrication and oil level
check" on page 58.
3. Install the platform on the arms, using the shafts
and bolts supplied. Tighten the bolts using a
torque wrench.
Tightening torque: 80 Nm.
4. Install one of the tilt cylinders on the platform.
Use the shaft and support wheel supplied.
!
IMPORTANT
Make sure the cylinder is installed with the grease
nipples facing up.
Lubricate the bushings and shaft! Use LE lubricant
4622 or the equivalent.
Tighten the bolts using a torque wrench.
Tightening torque: 80 Nm.
www.zepro.com
Z 1500/2000-135/155/175
NB! Lubricate the bushings
Figure 32. Take care to provide initial lu-
brication to the metal bushings
Figure 33. Install the platform on the arms
Figure 34. Install the tilt cylinder on the platform
23
Advertisement
Table of Contents
