Table of Contents
Advertisement
Rear member cut-outs
4.1
Prepare the tail lift
1. Position the support frame under the vehicle's chassis.
2. Remove the protective cap, secured with two quick-release locks, see Picture 16.
3. Fold out the control card (B) and loosen the cabling at the connector on the hydraulic unit, see Picture 17
and Picture 18.
4. Release the hydraulic unit by unscrewing the wing nut and corresponding screw (C); see Picture 19 and
pull out the hydraulic unit until the tank cap is accessible; see Picture 21.
m
CAUTION!
Ensure that no cables are trapped or in any other way damaged when the control card is folded out
or removed.
Do not pull out the hydraulic unit more than necessary; make sure it is not pulled completely out of
the frame, as this can entail a risk of personal injury and damage to the equipment.
Picture 16. Remove the protective cap
Picture 18. Connection socket
16
A
Picture 17. Release latch control card
C
Picture 19. Releasing the hydraulic unit
ZS MK2
B
www.zepro.com
Advertisement
Table of Contents
