Table of Contents
Advertisement
Installation
4.10.1 Controllers 3+1 (CD 1)
1. Fit the controllers in the desired locations. However,
locate them such that the operator's working posi-
tion is as safe as possible, and with an adequate
overview of the load, tail lift and their working area.
2. The distance between the vehicle's rear edge and
the centre of the controllers must be 300-600
mm. The distance between the controllers must
be at least 260 mm. See Figure 60.
3. Any additional controllers can be installed in an
optional location.
4. Run the controller cabling to the tail lift cable grom-
met. Connection is described later in section 6.
4.10.2 Controller UCU (CD 19)
Installation on the outside of the body
Because the cable is usually connected to the controller, and the latter is always bolted to the bracket,
disconnect the cable from the controller to run it through the wall.
1. Raise the connector latch to pull out the connector. See Figure 61.
2. When the cable has been pulled through the wall, reconnect it to the controller and secure it using the
latch. Then attach the controller securely to the body with the screws. See Figure 62.
www.zepro.com
Figure 61. Disconnecting the connector
300-600 mm.
Figure 62. Installing controllers
Z 1500/2000-135/155/175
300 - 600 mm.
Min. 260 mm.
Figure 60. Installing controller CD
1 with two-handed grip.
35
Advertisement
Table of Contents
