Table of Contents
Advertisement
Safety rules
3.6
Temporary connection
When the tail lift is installed, it is sometimes necessary to operate its functions in order to change the posi-
tion of the cylinders and the lift arms. Temporarily connect the lift to enable the lift functions.
1. Connect a suitable control device to Ctrl 1/C1, see section 3.6.2/3.6.3.
2. Connect the tail lift's main power cable to battery +12/24V.
3. Connect the negative battery terminal to the tail lift's earth cable (GND).
4. Relay card TLC-B1: When operating, connect a cable (jumper) between an available power supply con-
nection (+) and CS on the relay card to simulate switch CS being on. Remove the cable immediately after
completed operation.
Control card ZePRO1: When operating, connect the cable (jumper) between the CSPWR and CS on the
control card to simulate that the CS switch is turned on. Remove the jumper immediately after complet-
ed operation.
m
WARNING!
Take great care while running the lift functions and make sure nothing gets pinched: risk of personal injury and material
damage.
WL1 U7 U6 U5 U5 U4 U4 U3 U2 U1 U0
C1+
C1
C1+
Down
Up
2H
Tilt
Out
In
C2+
Down
Up
Tilt
C3+
Down
Up
TLC-B1
3.6.1
Battery maintenance
When installing the lift, when the lift is operated repeatedly, the battery charger must be used between opera-
tions to maintain the battery charge level.
!
IMPORTANT
The battery charger must not be connected when operating the lift. Risk of material damage.
www.zepro.com
Jumper
+
+
U3
U2
U1
+
+
U0
PA-
PA+
CS
WL2
CS+
S5+
S5
S4+
S4
S3+
S3
S2+
S2
S1+
S1
Figure 24. Temporary connection
Z 1500/2000-135/155/175
Outputs
B
Ctrl 1
E
Ctrl 1
C
2H1
B
E
Ctrl 2
C
2H2
Ctrl 6
B
E
Ctrl 3
Radio
C
Lock
Ctrl 5
B
E
Ctrl 4
Spiral
C
Lock
ZePRO1
+
Sensor Power
IN OUT
PA-
PA+
Jumper
CSPWR
CS
Di 6
Di 5
Di 4
Di 3
Di 2
Di 1
Ai 2
Ai 1
17
Advertisement
Table of Contents
