Table of Contents
Advertisement
Installation
5. Test the lift by carefully raising it to the vehicle
floor level and tilting it to the vertical position.
Check the position in relation to the rear beam
and side posts of the vehicle. See Figure 35 and
Figure 36.
4.2.1
Adjusting the tilt angle
!
IMPORTANT
Make no adjustments to the cylinders before installing
them on the platform. The tilt cylinders are factory preset.
1. Loosen the rubber bellows at the bottom where
they are secured with hose clips.
2. Run tilt-up until both tilt cylinders are fully
raised.
NOTE!
Always make adjustments with full hydraulic pres-
sure in the tilt cylinders.
3. Undo the three locking screws on the cylinder
mounted on the platform, Figure 37.
24
38 mm - 40 mm
Figure 35. Check the position in rela-
tion to the rear beam of the vehicle
Vehicle floor level
Type
Steel
A (mm)
70
Figure 36. The platform underhang (A), varies accord-
ing to platform type, and this should be taken into
consideration when installing the upper edge seal.
Out
In
Figure 37. Adjusting the tilt angle
Z 1500/2000-135/155/175
Applies only to assembly
with sealing strip
A
Aluminium
81
Locking screws, 3 pcs.
www.zepro.com
Advertisement
Table of Contents
