Table of Contents
Advertisement
Installation
4.2.2
Adjusting tilt-down angle
NOTE!
It is necessary to adjust the tilt angle 90º to the body
before adjusting the tilt down angle (see previous page).
m
WARNING!
To make sure the lift is safe and CE compliant, the
downward tilt angle must be adjusted to max 10° if people
will be present on the platform.
1. Run the lift up until the platform reaches the
vehicle floor. 3.6.
2. Loosen the lock screw of the end stop (2). Screw
the stop all the way back toward the platform (3).
Figure 44.
3. Tilt the platform down to max 10 degrees below
the horizontal plane. 3.6.
4. Adjust the end stop all the way to the top of the
cylinder (4). Figure 44.
5. Tighten the locking screw in the stop (5). See figure.
Figure 44.
Tightening torque for the locking screws is 3-5 Nm
Test all functions.
www.zepro.com
Adjusting collar
Lock screw
Bolt
Washer
Figure 45. Tilting cylinder
Z 1500/2000-135/155/175
Figure 43. The tilt angle must be ad-
justed to max.10° down
2
5
3
4
Figure 44. End stop with lock screw
End stop
27
Advertisement
Table of Contents
