Turning On The Device - Thermo Scientific VH-D20 Operating Manual

5 • Installation
5.7

Turning On the Device

Page 82
TIP
Before turning on the power to a Vanquish system module for the first
time, verify that the chromatography software is installed on the data
system computer. When the power is turned on, the required USB
drivers are automatically found and the Windows™ operating system
can detect the device.
To turn on the power to the device, follow these steps:
1. Check that the power button on the front left of the Vanquish
system base (system power button) is pressed in. If the power
button stands out, press the power button to turn on the power on
the system base.
2. Turn on the device with its main power switch.
Turn off the device with the main power switch, when instructed to do
so, for example, during maintenance. Pressing the system power button
will not be sufficient to turn off the power to the device completely.
NOTICE
Make sure that the pump flow to the detector is turned off. To properly
turn on the detector gas flow and only then turn on the pump flow to
the detector, follow the instructions in
Operation (} page 93).
See also
2 Power On/Off Control (} page 92)
Preparing the Device for
Charged Aerosol Detectors (VH-D20, VF-D20)
Operating Manual