Installing The Slide-In Module - Thermo Scientific VH-D20 Operating Manual

7.13.3 Installing the Slide-In Module

Tools required
Preparations
Follow these steps
Charged Aerosol Detectors (VH-D20, VF-D20)
Operating Manual
CAUTION—Heavy Load, Bulky Device
The device is too heavy or bulky for one person alone to handle safely.
To avoid personal injury or damage to the device, observe the following
guidelines:
• Physical handling of the device, including lifting or moving, requires
a team effort of two persons.
• A team effort is in particular required when lifting the device into
the system stack or when removing it.
Screwdriver, Torx T20
1. Unpack the replacement device. Remove the slide-in module from
the enclosure. See
2. Verify that the device enclosure into which the slide-in module shall
be installed is clean. If required, clean the inner and outer surfaces
of the enclosure. See
(} page 125).
3. When installing the slide-in module to an enclosure in the system
stack, check that the enclosure is placed correctly in the stack.
1. Push all tubing and capillaries, which are present in the tubing chase
of the Vanquish system modules, into the tubing chase. Otherwise,
you will not be able to insert the slide-in module properly into the
enclosure in the next step.
2. On the slide-in module, check that you can move the captive screws
back and forth with your fingers. If you cannot, screw them in until
you can.
7
Removing the Slide-In Module
Cleaning or Decontaminating the Device
• Maintenance and Service
(} page 148).
Page 151