5
•
Installation
Page 76
2. On the waste outlet on the detector, connect the waste line.
Figure 21: Waste line connected to the waste port
No.
Description
1
Waste outlet
2
Waste line
3. Check the waste line over the entire flow path. Make sure that no
bending (kink), pinching or squeezing of the waste line is present at
any point in the flow path.
4. If you have to cut tubing to length, use a tubing cutter. Make sure
that the cut is at right angle to the length of the line and that the cut
is not crimped.
TIP The waste line should go straight to the system base and to waste.
Make sure that the line is positioned straight in the tubing guides.
Charged Aerosol Detectors (VH-D20, VF-D20)
Operating Manual