CG CAPTIVA 7 Owner's Manual page 227

Head lamps (55 W)
1. Follow the steps described in section
Front lamps previously in this chapter,
to gain access to the lamp assembly.
2. Remove the dust cap covering the
head lamp bulb.
3. Disconnect the 2 headlamp connectors
by pushing on the thumb tabs.
4. Remove the dust cap covering the
head lamp bulb.
5. Remove the wiring connector from the
back of the bulb.
6. Release the spring retaining the bulb.
7. Remove the bulb and replace.
8. Install the wiring harness connector
and dust cap (ensuring the rubber
seal is in place).
9. Install components removed in step 1.
Refer to Front lamps previously in this
chapter.
10. Check lamp operation.
Parking lamps (5 W)
1. Follow the steps described in section
Front lamps previously in this chapter,
to gain access to the lamp assembly.
2. Remove the dust cap covering the
parking lamp bulb.
3. Pull out the parking lamp bulb
assembly located next to the head
lamp bulb.
4. Pull the bulb straight out of the bulb
holder.
5. Install the wiring harness connector
and dust cap (ensuring the rubber
seal is in place).
6. Install components removed in step 1.
Refer to Front lamps previously in this
chapter.
7. Check lamp operation.
BULB REPLACEmENT cont.
Chapter 6
EMERGENCIES
6-29
C100_6023
C100_6024