Locks - CG CAPTIVA 7 Owner's Manual

Pressing buttons
Note When pressing the key buttons, ensure that other keys on the key ring are not
between the key and the vehicle. Other keys can obscure the signal being transmitted
to the vehicle. Refer to Notes about the keys further on in this chapter.
Matching transmitter(s) to your vehicle
Each remote keyless entry transmitter is coded to prevent another transmitter from
unlocking your vehicle.
If a transmitter is lost, stolen or extras are required, a replacement can be purchased
through your Holden Dealer. Remember to bring any additional transmitters so they
can also be re-coded to match the new transmitter.
Once your Holden Dealer has coded the new transmitter, the lost transmitter will not
unlock your vehicle.
Up to 4 keys can be matched to your vehicle at the same time.
WARNING
The remote control unit contains precision electronic parts. To help avoid
transmitter trouble:
• Do not leave the remote control unit in direct sunlight.
• Do not treat the remote control unit carelessly.
• Do not allow the remote control unit to get wet or ingress moisture.
Replacing the battery in the
remote control
Replace the battery as soon as the range
of the remote control becomes reduced.
1. Remove the back cover by hand.
2. Remove the battery and replace it with
the new one, making sure the positive
(+) side of the battery is facing up.
Refer to Specifications in chapter 8
for the correct battery to be used.
3. Reassemble the transmitter ensuring
the cover is engaged correctly.
4. Test the operation of the transmitter
with your vehicle.
Note
• Avoid touching the flat surfaces of the battery with your bare fingers. Handling will
shorten battery life.
• Avoid touching the circuit board and other components inside the remote control.
kEYS cont.
2-3
Chapter 2

LOCKS