Bulb Replacement - CG CAPTIVA 7 Owner's Manual

Note If unsure of the bulb replacement process for any of the lamps, please have the
work carried out by a suitably trained service technician.
Notes when replacing bulbs
• Switch the ignition off (LOCK position) and remove the key.
• Switch off the related switch.
• It is important to fit only bulbs of the specified wattage.
• Do not touch bulbs or reflectors with bare hands. Greasy fingers cause stains
which evaporate, eventually resulting in a dull reflector. Grease spots on Halogen
bulbs will, within a short time, lead to bulb failure. Clean stained bulbs with
methylated spirits.
• Detailed procedures for headlamp aiming are given in the relevant service
manual for your vehicle. However, because headlamp aiming is a safety item it is
recommended that you have it carried out by your Holden Dealer.
Bulbs to be changed by your Holden Dealer
• Vanity mirror lamp
• Ignition switch lamp,
• Exterior mirror lamps
Front lamps
To gain access to the front park bulbs, front turn signal bulbs, high, low beam and
front fog bulbs:
3
1. Open the bonnet and remove the radiator cowl by unscrewing the 11 Phillips head
screws about 3 mm, then place a flat-blade screwdriver under each of the five
scrivets and gently pry them upwards. Remove the cowl.

BULB REPLACEmENT

,
3
3 .
Chapter 6
EMERGENCIES
6-27
C100_6039