Connecting A Video Endoscope - Pentax EPK-i7010 Instructions For Use Manual

Connecting a Video Endoscope

Connect an endoscope to the processor. Connect the water bottle assembly and suction unit to the endoscope before use. For
details on an endoscope, refer to the IFU for the endoscope.
1
Check to ensure the endoscope locking lever is
open.
2
Insert the endoscope firmly into connector 1 of the
processor. Close the endoscope locking lever in the
direction of 2 until it clicks into position. (Refer to
Figure 3.1.)
NOTE
 After connecting the endoscope to the processor, make sure
that the endoscope is firmly secured and that the endoscope
locking lever is in the LOCK position.
 On rare occasions, noise may be temporarily displayed on
3
endoscopic images immediately after the start-up video
processor or endoscope connection.
3
Fill the bottle approximately 2/3 full ( to the "200" marking on the bottle scale) with sterile water,
and then screw the cap onto the bottle and securely tighten it.
WARNING
Check whether there are any defects such as cracks on the water bottle assembly exterior. If there is a defect on the
water bottle assembly, do not use it.
NOTE
Do not overtighten the water bottle cap.
4
Align the A/W DRAIN lever with the A/W (air/water
supply) position. (Refer to Figure 3.2.)
5
Insert the air pipe of the water bottle assembly into
the water bottle socket of the processor until it clicks
into position.
NOTE
Do not use excessive force when pushing the water bottle
towards the processor. Rough handling may cause water to leak
from the bottle onto/into the video processor.
• Insert the air/water connector into the holder on the water bottle
cap until the endoscope is connected. (Refer to Figure 3.3.)
NOTE
 Remove the water bottle assembly before moving the
processor to a place other than the usual place of use.
 Remove the water bottle assembly before packing the
processor for transportation.
17
Preparation
2
1
Light Guide
Figure 3.1
A / W
Figure 3.2
Figure 3.3
Endoscope
Locking Lever
Electrical
Connector
DRAIN