Nomenclature, Controls, And Functions; Main Unit - Pentax EPK-i7010 Instructions For Use Manual

2

Nomenclature, Controls, and Functions

Main Unit

Water Bottle Socket
Insert the air pipe of a
PENTAX Medical water
bottle assembly.
2
Air Intake Vent
Allows for ventilation and
cooling of the lamp/unit.
Do not block the grids.
Note
Install the processor
in a location where
the air intake vents
will not be blocked.
Water Bottle
Assembly
I "PENTAX Medical
Water Bottle Assembly
(OS-H5)"(P.8)
NOTE
 Always insert an endoscope prior to turning on the processor. Also, always turn off the processor before removing an
endoscope.
 Before turning on the processor, make sure the air intake vents are not blocked.
 The lamp of the processor should be turned off except during pre-use inspections and clinical use.
 After connecting an endoscope to the processor, check that the endoscope is firmly secured and that the endoscope
locking lever is in the LOCK position.
 Immediately after use, the metal light guide prong and the electrical contacts/pins of the endoscope may be hot. To
avoid burns, do not touch these parts immediately after use. For safe handling after a procedure, grasp the PVE
connector housing of the endoscope.
 The light emitted by the Xenon lamp is extremely intense. Avoid looking directly at the light exiting this equipment
without Light Guide Receptacle being attached.
5
Nomenclature, Controls, and Functions
Lamp Protective Cover
Open this cover when you
want to replace the lamp
cartridge.
Light Guide Receptacle (AE-P2)
Insert the light guide of a video endoscope or
fiberscope. Use in combination with a video module
of a fiberscope is possible.
When using an adapter other than AE-P2, contact
a PENTAX Medical service facility.
Endoscope Electrical Connector
Insert the electrical connector of a video
endoscope or video module (fiberscope).
Endoscope Locking Lever
Open the lever before connecting or
removing an endoscope. After connecting
an endoscope to the processor, close the
lever.
Touch Panel
I "Touch Panel"(P.6)
Power Switch R
Press this switch to turn
the processor on or off
USB Port
Connect "Image Recording
Media"(P.91) or USB printer.
.