Pentax EPK-i7010 Instructions For Use Manual page 17

 Connecting Peripheral Devices
Connect the peripheral devices to the processor. Make sure the processor and peripheral devices are turned off beforehand.
WARNING
When connecting peripheral equipments to the processor, use only the cables specified in this IFU. If different cables
are used, the equipments' resistance to the electromagnetic waves will change, and the equipments could cause
adverse effect to each other. If you use different cables, please contact your local PENTAX Medical service facility.
 Before connecting peripheral devices, check that the devices operate correctly.
 Before connecting or removing peripheral devices, make sure the processor and peripheral devices are turned off.
 To avoid malfunction caused by changing the connecting configuration, use after confirming the normal operation of
the processor and the peripheral devices by checking adequately.
 Since the processor may not operate normally if the peripheral devices are removed while in use, be sure to remove
them after turning off the power.
 To avoid malfunction caused by updating or upgrading of the peripheral devices, use after confirming the normal
operation of the processor and the peripheral devices by checking adequately.
 When used near a radio or TV receiver in clinical or residential areas, the processor may be subjected to radio
interference.
 To reduce electromagnetic interference, do not keep turning on the main power switch of the processor while an
endoscope is connected but not ready for use.
 To avoid and resolve adverse electromagnetic effects, do not operate the processor near RF (Radio Frequency)
generating equipment.
 Connecting a Monitor or Recorder
Connect a monitor or recorder to the processor. For details, refer to the IFU for the monitor and recorder.
 The range of display may not match with the following connection methods because the image output specifications
differ.
Connecting a monitor or recorder with an HD-SDI input connector (BNC) (recommended)
Use the PENTAX Medical HD-SDI cable (OS-A85) to connect an HD-SDI connector to an HD-SDI input connector on the
monitor(26"Radiance G2 HB).
HD-SDI Cable OS-A85
DVI Cable OS-A78
VGA Cable OS-A74
RGB Cable OS-A25
Y/C Cable OS-A24
BNC Cable
OS-A17
Monitor
12
Preparation
3