Touch Panel - Pentax EPK-i7010 Instructions For Use Manual

Touch Panel

COLOR BALANCE Button c
Use this button to display the color
balance adjustment screen.
I "Color Balance Button"(P.28)
Customize Buttons
Each press of a button changes the
setting of the indicated function.
You can set the functions you use
very frequently for these four
buttons. Depending on the
function, the setting may be
displayed on the top right of a
button.
I "Customize Buttons"(P.29)
MODE Button b
Use this button to select
the light measuring
method.
AVERAGE:
Adjust the
[BRIGHTNESS]
level in relation
to the average
value of the
brightness of the
video signal.
PEAK: Adjust the
[BRIGHTNESS]
level in relation
to the maximum
value of the
brightness of the
screen.
I "Mode Button"(P.28)
SETUP Button e
NOTE
 The lamp life is 500 hours. Check the LIFE indicator (lamp life indicator) on the touch panel before using the
processor. Replace the lamp cartridge if a red circle is displayed on the LIFE indicator. The lamp life may not be as
long as 500 hours depending on the method of use and operating environment.
I "Replacing the Lamp"(P.82)
 When pressing a button on the touch panel, make sure to press the center of the button. If the edge of the button is
pressed, the system might activate the button that is next to the button you intended to press.
 When pressing a button on the touch panel, make sure that the setting/configuration change that was intended to be
made in the previous press has been correctly applied. Pressing a button in succession may cause a system error.
If a system error occurs, turn the power off and then on again.
EXPOSURE CONTROL Button a
Use this button to change the method of
adjusting the screen brightness.
AUTO: Adjust the screen brightness
automatically.
MANUAL: Adjust the screen brightness
manually.
I "Exposure Control Button"(P.28)
Use this button to display the
setting menus.
I "Setup Button"(P.29)
XLUM ON/OFF Button d
Use this button to maximize the
endo
light intensity of the scope.
I "XLUM ON/OFF
Button"(P.29)
WHITE BALANCE Button P
Lamp Life Indicator [LIFE]
The lamp usage time is indicated by this indicator.
3 green circles: Less than 400 hours
2 green circles: 400 hours to 449 hours
1 yellow circle: 450 hours to 499 hours
1 red circle: 500 hours or more (the lamp needs to
be replaced)
I "Replacing the Lamp"(P.82)
Nomenclature, Controls, and Functions
Brightness Setting
Buttons
Use UV to
adjust the brightness
level.
I "Brightness
Setting Buttons"(P.26)
Pump Level Setting
Buttons
Use UV to adjust the
strength of the pump.
I "Pump Level Setting
Buttons"(P.27)
LAMP Button S
Use this button to turn the
lamp on or off.
I "Lamp Button"(P.26)
PUMP Button Q
Use this button to operate
or stop the air/water
pump.
I "Pump Button"(P.26)
Use this button to adjust the
white balance.
I "White Balance
Button"(P.27)
6
2