Pentax EPK-i7010 Instructions For Use Manual page 42

 i-scan profile
Set the functions of [i-scan1], [i-scan2], and [i-scan3].
1
Press [>].
• The [i-scan profile] screen appears.
• The setting value in the main screen and other screens is
displayed for each item.
2
Select [i-scan1], [i-scan2], or [i-scan3].
• If one of the i-scan modes is already selected, the currently
enabled button will be lit.
3
Press the parameter box for which you want to
change the setting.
• When a parameter box is selected, it turns blue and the buttons
for changing the selected parameter appear at the bottom of the
screen.
4
Change the setting with the buttons at the bottom of
the screen.
• [SE] [CE] [TE] and [OE] cannot be processed simultaneously.
5
Press [Save].
• The changes are saved.
• If [Load] was pressed when the setting values were changed, the saved setting values are loaded.
5
List for assignable i-scan setting
Setting Item
Enhancement (Enh)
SE (Surface Enhancement)
CE (Contrast Enhancement)
TE (Tone Enhancement)
OE (Optical Enhancement)
Brightness (B)
Ave / Peak (Light Measuring Method)
Red / Blue (Color Balance)
Noise Reduction (NR)
NOTE
 With [Brightness] and [Ave/Peak], [No change] can be selected in addition to the normal levels. [No change] enables
the level for when the [i-scan] setting is [Off] to be used.
 If you attempt to perform a keyboard operation other than pressing the [Lamp] or [Pump] key, endoscope button
operation, or foot switch operation in the [i-scan profile] screen, the message "Close profile menu." appears on the
monitor and the operation cannot be performed.
37
Operating Procedure
Setting Value
Off, +1, +2, +3, +4, +5, +6, +1/a1, +2/a2, +3/a3, +4/a4, +5/a5, +6/a6
Off, +1, +2, +3, +4, +5, +6
Off, +1, +2, +3, +4, +5, +6
Off, p, v, b, e, g, c
Off, Mode1, Mode2
-5, -4, -3, -2, -1, 0, +1, +2, +3, +4, +5
Average, Peak
-5, -4, -3, -2, -1, 0, +1, +2, +3, +4, +5
Off, Low, Medium, High
Select the i-scan Load the setting values
mode to set. of a saved i-scan mode.
Load the recommended setting values.
Change the parameter settings.
Press the parameter box for which you want
to change the setting.
Save the changes.