Pentax EPK-i7010 Instructions For Use Manual page 74

 Configuration copy
Copy the system configuration data of the processor to "Image Recording Media" (P.91).
1
Press [Output].
• The [Configuration copy] screen appears. The Image Recording
Media currently connected and the total size and free space of
each Image Recording Media is indicated on the screen.
• If you connect Image Recording Media after displaying the
screen, press [Refresh] to perform recognition of the Image
Recording Media.
2
Press the button of the Image Recording Media to be
used as the copy to destination.
3
Press [Output].
• The system configuration data is copied to Image Recording
Media.
NOTE
If the configuration data is copied properly, the message "Configuration saved." appears on the monitor. If it is not copied
properly, the message "Copy failed." appears on the monitor.
 Configuration load
5
Load the system configuration data saved in "Image Recording Media" (P.91) to the processor.
1
Press [Load].
• [Configuration load] screen appears. The Image Recording
Media currently connected and the total size and free space of
each Image Recording Media is indicated on the screen.
• If you connect Image Recording Media after displaying the
screen, press [Refresh] to perform recognition of the Image
Recording Media.
2
Press the buttons of the Image Recording Media with
the system configuration data to load.
3
Press [Load].
• The system configuration data is loaded to the processor.
NOTE
 The system configuration data is loaded from the file "EPK-i7010ConfigurationDataEx.dat" in Image Recording
Media.
The following files cannot be read.
"EPK-i7000ConfigurationData.dat", "EPK-i7010ConfigurationData.dat"
 The files saved other model's system settings cannot be read.
 If there is no data to load in Image Recording Media, the message "No data." appears.
 Configuration load is not available while the endoscope is being connected.
69
Operating Procedure
Indicates the Image Recording Media
currently connected and the total size and
free space of each Image Recording Media.
Perform Image Recording
Media recognition again.
Copy the system configuration.
Indicates the Image Recording Media
currently connected and the total size and
free space of each Image Recording Media.
Perform Image Recording
Media recognition again.
Load the system configuration data.