Image Processing Settings
Be sure to check that the endoscopic images on the monitor are not static and that the images are displayed with the
correct orientation each time after changes have been made to image processing settings.
Using SE
1
Press the [SE] key on the keyboard / customize button on the touch panel or configure setting
on [i-scan] Tab.
• Each press changes the level of SE.
I "Function Keys" (P.73), "Customize button settings" (P.44), "[i-scan] Tab" (P.35)
SE is an observation mode that employs software image enhancement of regional concavity and convexity after the
image has been collected by the endoscope.
All mucosal areas are to be viewed using traditional white light. SE should not be used as a substitute for a thorough
traditional white light examination of the mucosa.
Using CE
1
Press the [CE] key on the keyboard / customize button on the touch panel or configure setting
on [i-scan] Tab.
• Each press changes the level of CE.
5
I "Function Keys" (P.73), "Customize button settings" (P.44), "[i-scan] Tab" (P.35)
NOTE
If [Enhance level], [SE], or [CE] is set to high level, noise may become visible in images on the monitor screen.
[Enhance level], [CE], [SE] settings are stored in memory even if the processor is turned off.
K series with CE: Equivalent effectiveness to i series with CE mode.
Using TE
1
Press the [TE] key on the keyboard / customize button on the touch panel or configure setting
on [i-scan] Tab.
• Each press changes the mode of TE.
• Select from [p], [v], [b], [e], [g], [c], and [off].
I "Function Keys" (P.73), "Customize button settings" (P.44), "[i-scan] Tab" (P.35)
NOTE
K series with TE [e], [g], [c]: Equivalent effectiveness to i series with TE [e], [g], [c] mode.
33
Operating Procedure