Pentax EPK-i7010 Instructions For Use Manual page 61

 CE setting
Specify the CE display levels that can be switched using a customize button on the touch panel, endoscope button, foot switch,
or keyboard.
1
Press [>].
• The [CE setting] screen appears.
• The level that is currently specified is indicated by green
characters at the top of the screen.
2
Press the buttons of the levels you want to use.
• The selected level buttons illuminate blue.
• Pressing a button again cancels the selection.
3
Press [OK].
• If you switch to another screen without pressing the [OK] button,
the settings will not be applied.
 TE setting
Specify the TE display modes that can be switched using a customize button on the touch panel, endoscope button, foot switch,
or keyboard.
1
Press [>].
• The [TE setting] screen appears.
• The mode that is currently specified is indicated by green
characters at the top of the screen.
2
Press the buttons of the modes you want to use.
• The selected mode buttons illuminate blue.
• Pressing a button again cancels the selection.
3
Press [OK].
• If you switch to another screen without pressing the [OK] button,
the settings will not be applied.
 OE setting
Specify the OE modes that can be switched using a customize button on the touch panel, endoscope button, foot switch, or
keyboard.
1
Press [>]
• The [OE setting] screen appears.
• The mode that is currently specified is indicated by green
characters at the top of the screen.
2
Press the buttons of the modes you want to use.
• The selected mode buttons illuminate blue.
• Pressing a button again cancels the selection.
3
Press [OK].
• If you switch to another screen without pressing the [OK] button,
the settings will not be applied.
The level that is currently specified is
indicated by green characters.
Select the levels you want to use.
Confirm the selection.
The mode that is currently specified is
indicated by green characters.
Select the modes you want to use.
Confirm the selection.
The mode that is currently specified is
indicated by green characters.
Select the modes you want to use.
Confirm the selection.
Operating Procedure
5
56