Changing The Cms Admin Password - FLIR DIGIMERGE DNR316P1 Instruction Manual

FLIR SyncroIP NVR Central Management Software
• Auto Login FLIR SyncroIP NVR CMS: Check for the CMS to automatically log in the admin
account when it is opened.
• Hotkey Setup: Configure hotkeys for the CMS. Use the drop-down menu to select the command,
and then click inside the box on the right and enter the hotkey.
NOTE: Do not use F12 as a hotkey. F12 is reserved for the system debug command.
• Displayed items in the right bar: Select which right-side menu is opened when the CMS opens.
• Record Time (M): Select the length in minutes of video files recorded on your computer hard
drive. For example, if you select 15 minutes, the system will save a new video file for every 15
minutes of recording.
• Snapshot picture path: Click ... to select the default save folder for snapshots.
• Picture file name rule: Click ... to define the file name rule for snapshots.
• Recorded file path: Click ... to select the default save folder for manual recordings.
• Recorded file name rule: Click ... to select the file name rule for manual recordings.
• Downloaded file path: Click ... to select the folder for downloaded recording files.
• Download record file name rule: Click ... to define the file name rule for downloaded recording
files.
• Device free minimum space (MB): Enter the amount of minimum space in MB to maintain on
the computer hard drive. The system will stop recording when only this much space is left.
• Auto Start Project: Check for the CMS to automatically run a project when opened. Select the
project it will run under Project Name.
• Auto Start Task: Check for the CMS to automatically run a task when opened. Select the task
it will run under Task Name.
• Last Run: Check for the CMS to start the last used task or project when opened.
• Save last monitor status: Check to have the CMS restore the previously used display mode
when opened.
• Auto sync PC time to device: Check to have the NVR sync the clock with the system time on
the PC.
• Sync time becomes valid at: Select the time that the NVR will sync its clock with the PC's
system time.
• Week: Select days that the NVR will sync its clock with the PC's system time.
• Auto reboot device: Check to enable the NVR to reboot when the time sync occurs.
3. Click Ok to save changes. Close the CMS and restart it to update the configuration.

Changing the CMS Admin Password

You can change the admin password that is used to log into the CMS. The default password is
admin.
NOTE: The CMS will automatically populate the admin password unless you enable Verify
Password under Config>Options.
54