Step 5: Connect To Power; Step 6: Create A Secure Password; Step 7: Upgrade Firmware To Latest Version (If Available) - FLIR DNR214 Instruction Manual

5 Basic Setup
1. VGA cable (not included) — supports up to 1080p output.
2. HDMI cable (included) — supports up to 4K output.

5.5 Step 5: Connect to Power

Connect the included power adapter to the NVR and connect the other end to a wall sock-
et or surge protector.
At startup, the system performs a basic system check and runs an initial loading sequence.
After a few moments, the system loads a live display view.

5.6 STEP 6: Create a Secure Password

The first time you power up your system, you will be asked to create a new 6 character
password.
1. Enter the system user name (default: admin) and password (default: 000000).
2. You will be asked to create a new 6 character password. Enter your new password
in the New Password and Confirm Password fields, then press OK to confirm.
NOTE
Your new password will be used to access the system from now on.

5.7 Step 7: Upgrade Firmware to Latest Version (if Available)

If a firmware upgrade is available, you will be asked to install it once the NVR starts up. It is
required to upgrade your system firmware and client software / mobile apps to the latest
version to enable remote connection to the system.
If a firmware upgrade is available:
1. After startup, a notification will appear asking you to upgrade the firmware. Click OK to
upgrade.
2. Enter the system user name (default: admin) and your new, secure password.
#LX400094; r.43927/43955; en-US
9