Appendix B: Setting Up Remote Viewing; What Do I Need - FLIR DIGIMERGE DNR316P1 Instruction Manual

Appendix B: Setting up Remote Viewing

APPENDIX B: SETTING UP REMOTE
VIEWING
Setting up the Remote Viewing Feature requires several steps. Networking skills are required to
correctly configure the remote viewing functions.

What Do I Need?

• NVR System.
• A PC with the installed CMS software.
NOTE: For Mac users, please visit
• A router (not provided with the system) and High Speed Cable or DSL Internet Connectivity
(for remote viewing outside your network).
Network Setup / Remote Access Overview
To setup remote viewing:
1. With the system powered off, connect the system to the router using an Ethernet cable.
INTERNET
2. Power the system on.
3. Press the Enter button on the remote control or front panel to find your system's IP address.
4. Enable Port Forwarding on your router for the Client (default: 35000) and HTTP Ports
(default: 80). To set up port forwarding, use the included Auto Port Forwarding Wizard
software (see "Appendix C: Auto Port Forwarding Wizard" on page 91) or refer to your router
manufacturer's instructions.
5. Setup an account at http://ddns.myddns-flir.com. For details, see "Appendix D: Setting Up
DDNS Service" on page 98.
88
www.digimerge.com for instructions.
NVR*
ROUTER
(Not Included)
PC
(Not Included)