Appendix F: Hard Drive Installation; Installing A Hard Drive - FLIR DIGIMERGE DNR316P1 Instruction Manual

Appendix F: Hard Drive Installation

APPENDIX F: HARD DRIVE INSTALLATION
The system comes with one or more pre-installed 3.5" SATA hard drives. You can install up to two
hard drives up to a maximum size of 3TB each (for a maximum total storage of 6TB).

Installing a Hard Drive

Make sure that the system is OFF and ALL power adapters have been
disconnected before removing/installing the hard drive.
To remove the hard drive:
1. Power off the system, and unplug all wiring / cabling from the system.
2. Remove the screws (4x) from the back panel. Slide the cover back and up to remove.
3. Insert hard drive screws (4x) on the hard drive and tighten them half way.
4. Place the hard drive over one set of screw holes on the bottom panel with the SATA power and
data connectors facing the middle of the unit. Slide the hard drive into place.
Hard drive screw holes
104
Insert hard drive screws
(4x) and tighten half way
Place hard drive over screw
holes and slide into place