Device Search; Adding Cameras From The Lan - FLIR DIGIMERGE DNR316P1 Instruction Manual

Device Search

The Device Search menu allows
you to manage connections to
your IP cameras. SyncroIP cameras connected
to the PoE (Power over Ethernet) Ports will
automatically be detected by your NVR. Device
Search also allows you to search for IP
cameras connected to the LAN. Some
configuration may be required to connect IP
cameras from other manufacturers.
NOTE: For a list of 3rd party IP cameras
supported, visit www.digimerge.com.

Adding Cameras from the LAN

1. Connect the camera to a router or switch
on the same network as the NVR.
2. Right-click and select Device Search. Log
in using the admin account (the default
User Name is admin and the default
Password is 000000).
3. Click IP Search. The NVR scans your LAN
for compatible IP cameras.
Check IP
Search
4. Check the camera(s) you would like to add
and click Add.
Check
cameras
Click Add
5. If the Status indicator is green, the camera
is connected and no further configuration
is required. Click OK to save changes.
6. If the Status indicator is red, click
Update the following information, as
needed.
• Manufacturer: Select the manufacturer of
your IP camera.
• User: Enter the camera's user name.
• Password: Enter the camera's password.
• RTSP Port: Enter the camera's RTSP Port.
• HTTP Port: Enter the camera's HTTP Port.
NOTE: See the manufacturer's user manual
for your IP camera for the default user
name, password, etc.
7. Click OK. Click OK again to save changes.
Manual Add
If the IP address of your IP camera does not
appear when you run IP search, ensure that
the camera is connected to the same LAN as
Using the Main Menu
.
31