FLIR DIGIMERGE DNR316P1 Instruction Manual page 120

Troubleshooting
• Hard drive is not • Hard drive cables are loose or
detected by the not properly connected
system
• Hard drive has not been
initialized (formatted) by the
system
• There is no hard drive in the
system
• Hard drive is full • Overwrite is not enabled
and the unit is no
longer recording
• Mouse not detected • Mouse cable is not firmly
by system connected to the system
• Mouse is not connected to the
system
• System needs to be reset
• My system does not • Recording may be disabled
seem to be recording
110
• Remove the housing and check that hard drive
cables are firmly connected
• For details, see "Formatting the Hard Drive" on
page 107
• Open the housing and install a 3.5" SATA hard
drive
• From the Main Menu, select General. Beside HDD
Full, select Overwrite. Click OK to save settings.
This enables the system to continuously record by
overwriting data once the hard drive is full
• Firmly connect the mouse cable to the system
• Re-connect the power cord to restart the system.
• Right-click in live view, and click Record. Ensure
that each channel is set to Schedule or Manual. If
schedule is selected, make sure schedule settings
are correct under Setting>Schedule.
ATTENTION
: For security, it is highly
recommended to keep Continuous Recording ON at
all times