Running Tasks And Projects; Using E-Map; Configuring E-Map - FLIR DIGIMERGE DNR316P1 Instruction Manual

FLIR SyncroIP NVR Central Management Software
5. Under Mode, select Tour Mode or Schedule Mode. Tour Mode will cycle through tasks on a
fixed interval. Schedule Mode will switch tasks at a pre-defined time of the day.
Enter project name
Select project type
Select task
Enter interval or start time
6. Under Task Name, select the task you would like to add to the project.
• If you selected Tour Mode, enter the Interval Time in minutes that the task will run for before
changing to the next task.
• If you selected Schedule Mode, enter the time of day when the task will start running.
7. Click Add.
8. Repeat steps 6-7 for each additional task you would like to add to the project.
9. Click OK. Click OK to save changes.

Running Tasks and Projects

• Once you have configured tasks or projects, you may run them by clicking Task (
then selecting the task or project you would like to run.
• You may also select a task or project to run when you first launch the CMS. For details, see
"Configuring CMS Options" on page 53.

Using E-Map

The E-Map feature allows you to visually map your cameras over a .jpg image.

Configuring E-Map

Use the steps below to select a .jpg image to use for the E-Map and place your cameras.
To configure the E-Map:
1. Click Config Manager>E-Map Config.
50
Click Add
) and