Table of Contents
Advertisement
to enable or disable areas for motion
detection. Right-click when finished.
Click and drag to enable/disable areas for motion detection.
Enabled areas are red.
5. Under Sensitivity, select the motion
detection sensitivity between 1 (lowest)
and 6 (highest).
6. Under Anti-dither, enter the anti-dither
time. After a motion event occurs and
motion stops, if motion is detected within
the anti-dither time, the system continues
the motion event and includes the new
motion within the first event, rather than
creating a new motion event.
7. Under Delay, enter the post-recording
time.
8. To configure a schedule when motion
detection will be enabled on this channel,
click Set next to Period. Configure times
when motion detection will be enabled. For
example, you may want to disable motion
detection during business hours and
enable it outside of business hours. Click
OK when finished.
NOTE: This setting can override scheduled
motion recording. This means that motion
recording will only take place at times that
are enabled both in the Schedule menu and
here.
9. Configure the following system actions
when motion is detected:
• Show Message: Check to enable an
on-screen pop-up. On-screen pop-up
shows the channels an event occurred on
and the type of event.
• Send Email: Check to enable email alerts.
You must configure email alerts before you
will be able to receive them (see
"Configuring Email Alerts" on page 27).
• Record Channel: Select the channels that
will record when motion is detected on the
selected channel.
• Buzzer: Check to enable the system
buzzer.
• Snapshot: Check to attach a .jpg image of
the camera when sending email alerts.
10. Click Save to save changes.
Display
The Display sub-menu allows you to configure
the system's display settings, such as the
monitor resolution.
To configure display settings:
1. Configure the following, as needed:
• Transparency: Select the menu
transparency between 128 (lowest) and
255 (highest).
• Channel Name: Click Modify and enter
names for your IP cameras. Click Save
when finished.
• Time Display: Check to enable system time
display.
• Channel Display: Check to enable camera
title display.
• Resolution: Select the correct resolution
for your monitor. The system will reboot
when you save changes.
Using the Main Menu
29
Advertisement
Table of Contents
