Table of Contents
Advertisement
Chapter 3 Advanced Operation
3-5.
Registering the folding value directly while processing
The current folding settings can be registered for later reference when performing operations under the
same conditions.
Test fold or perform folding process, check folding misalignment, and ine-adjust when registering the value.
1
Press the menu key to display the [Irreg Set] screen.
2
Input the registration number on the
keypad or the
3
Press and hold the custom folding key.
A buzzer sounds "pii", and the data will be registered.
4
Press the
key.
Returns to the top screen.
4.
Cross Fold
Cross fold is folding single-folded paper again as shown in the igure.
The upper limit of paper thickness is 127.9 g/m
paper (cross fold only).
Rough paper may be thin and limsy, and therefore inappropriate for cross fold.
• Paper Σ dent and folding misalignment
in both directions may increase or paper
may be fed unstably depending on the
following conditions. However, it is not a
malfunction.
- The folded line of single-folded paper
is not folded properly.
- Folding environment (temperature and
humidity)
- Paper thickness, paper size, paper
type, or paper grain direction, etc.
• Double-feed detection does not operate when cross fold is performed. Select the setting
[OFF].
3-12
key.
2
/34 lb for ine quality paper and 157 g/m
01
Irreg Set
P Length
Fold1
Fold2
2
/40 lb for coated
∑ dent
Advertisement
Table of Contents
