Formax FD 3200 Instruction Manual page 30

Chapter 2 Basic Operation
When processing long paper, use the plate unit and side guide unit.
Range of paper length: A3 (LGR) or more, or back edge of paper is positioned at more than two-third of
auxiliary paper feed tray.
6
Set the plate unit onto the auxiliary
paper feed tray.
Be sure to set the plate unit so that it does not
extend beyond the rear end of paper.
7
Attach the side guide unit on each side
of paper.
Attach the side guide unit leaving some
clearance between the side guide unit and
paper. However, if the side guide unit is set
leaving too much clearance between the
side guide and paper, accuracy of feeding
may be lowered, and folding misalignment
may be apt to occur. If the side guide unit
is set striking at the paper, double-feed or
mis-feed may be caused.
Automatic rise/descent of the paper feed tray
• When paper is stacked on the paper feed tray, the paper feed guides are set, and the start or test key is
pressed, the paper feed tray rises automatically.
When using large or heavy paper, the paper feed tray may become over stacked and may not be
able to rise due to paper weight. In such cases, stack less paper.
• The paper feed tray will descend under the following conditions or after the following operations.
Paper is removed from the paper feed tray.
Paper runs out during folding operation.
The stop key is pressed during folding operation to stop processing.
The key is pressed in the stand-by state. (The paper feed tray descends while the
pressed.)
2-4
key is being