Formax FD 3200 Instruction Manual page 91

Condition
Paper feed interval is not
stable.
The leading edge of paper
does not misaligned too
much, but double-feed
occurs.
Double-feed occurs with
the leading edge of paper
misaligned largely.
Cause
Paper is curled.
Thick paper is used.
Paper is sticking and diicult to separate.
Paper out of speciications is used.
Paper is not stacked in alignment.
Loaded paper is more than 50 mm/
1.96 inches in height.
The separating air adjustment knob is not
positioned correctly.
Separating air volume is too large.
Pickup air volume is too large.
The clearance between the separator and
suction belt is too large.
The stack height sensor is not positioned
correctly.
Paper is put on the paper detection sensor. Stack paper again on the paper feed tray.
Paper out of speciications is used.
Paper is not stacked in alignment.
Loaded paper is more than 50 mm/
1.96 inches in height.
The side guide unit is pressed against the
paper strongly.
The separating air adjustment knob is not
positioned correctly.
Separating air volume is too low
Pickup air volume is too large.
The clearance between the separator and
suction belt is too large.
The stack height sensor is not positioned
correctly.
Chapter 5 Trouble Guide
Solution
Correct the paper curl before use.
Set the stack height sensor to irst scale
(p.2-8)
from the bottom.
Check that the printing ink of the paper has
dried and there is no static electricity, and
then separate the paper well.
Do not use paper outside the speciications.
(p.1-12)
Stack the paper in alignment.
Load paper so that it is less than
50 mm/1.96 inches in height.
Turn the separating air adjustment knob to
(p.2-8)
small scales.
Turn down [Sep. Air] volume by [5] scales at
(p.2-6)
a time.
Turn down [Pickup Air] volume by [5] scales
(p.2-6)
at a time.
Turn the separator adjustment knob to
(p.2-8)
small scales.
Set the stack height sensor to the standard
(p.2-8)
position.
Do not use paper outside the speciications.
(p.1-12)
Stack the paper in alignment.
Load paper so that it is less than 50 mm/
(p.2-2)
1.96 inches in height.
Set the side guide unit leaving some
clearance between the side guide unit and
(p.2-4)
paper.
Turn the separating air adjustment knob to
(p.2-8)
large scales.
Turn up [Sep. Air] volume by [5] scales at a
(p.2-6)
time.
Turn down [Pickup Air] volume by [5] scales
(p.2-6)
at a time.
Turn the separator adjustment knob to
(p.2-8)
small scales.
Set the stack height sensor to the standard
(p.2-8)
position.
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
(p.1-13)
(p.1-13)
(p.1-14)
(p.2-2)
(p.1-14)
(p.1-14)
5-11