Advertisement
Window
frame.
84.
To reduce possible water from penetrating
into the window cavity, caulk gap on both sides
of window opening prior to installing Window
Insert. Position insert in cavity and screw with
6 - 1 1/4" Screws. On sides, make sure to
screw insert into the thick butt of the siding only.
85.
Position Window Trim around window doing a dry run first and
attach with 4 - 1 1/2" Finishing Nails per piece. There are two Trim Kits
(Regular/Narrow). The regular window kit = 1" x 24 1/16"=top (angle cut
on ends), 3" x 23" = Sides and Bottom. Narrow window kit = 1" x 19 7/8"
Top, 2" x 21 7/16" Sides, 1" x 18 3/4" Bottom. Window trim has a small
dado on reverse face. Outside flange of window will roughly sit in the
dado to give a better fit.
Toll Free 1-888-658-1658
Caulk
gap.
Screw insert into
bottom (thick)
part of siding.
Reg Window x 4
Narrow Window x 8
S2 - 1 1/4" Screws
Trim dado
sits in flange.
www.outdoorlivingtoday.com
Page 45
Parts
Hardware
x 72 total
84b.
caulk
Caulk
between the Insert's outside
gap.
flange and the siding. Also put
a bead of caulking horizontally
at top of window where the
flange and siding meet.
additional caulking will also will
reduce the chances of moisture
entering into your shed.
Hardware (Step 85)
N1 -1 1/2" Finishing Nails
Regular Window Trim x 4
Narrow Window Trim x 8
sales@outdoorlivingtoday.com
Once Insert is attached,
the
"triangular
x 192 total
Parts (Step 85)
gap"
This
Advertisement
