Advertisement
12.
Starting with Solid Wall Panels, carefully lay
panel face down. Position and attach Wall Plate to
bottom of wall studs of each Wall Panel with 3 - 2
1/2" screws. Position so plates are flush with fram-
ing. Note: Bottom Wall Plates may already be
attached to some Solid Walls.
13.
Starting at Rear Corner, position a Solid Wall
Wall Panel on top of plywood floor. Make sure panel
is facing up. The Side Wall Panels will sit flush with
floor frame with the front and rear panels sandwiched
between them. Note: siding will overhang the floor
by approx. 1/2".
Toll Free 1-888-658-1658
Bottom Wall Plate
Important: Make sure all walls are
aligned in their upright position. If
not ,water may leak into your shed.
Unsure if panel is facing up or
down? check siding on window wall
panel to match alignment.
www.outdoorlivingtoday.com
Pilot hole ALL 2x3 Wall Studs
with 1/8" drill bit prior to screwing.
This will make it much easier to
Parts (Step 12)
Solid Wall Panels
(45 1/2" x 81 3/4") x 4
Solid Wall Panel - Extra Studs
(45 1/2" x 81 3/4") x 1
Bottom Wall Plates
(1 1/2" x 2 1/2" x 45 1/2") x 5
Side Wall Panel
2x3 Plate of wall panel is
flush with floor frame. Siding
overhangs floor by 1/2".
Parts (Step 13)
Solid Wall Panels
(45 1/2" x 81 3/4") x 4
Solid Wall Panel - Extra Studs
(45 1/2" x 81 3/4") x 1
Window Wall Panels
(45 1/2" x 81 3/4") x 4
Double Window Walls
(45 1/2" x 81 3/4") x 4
Page 13
Important:
attached together.
Pilot
Hole Plate
first.
Hardware (Step 12)
S1 - 2 1/2" Screws
x 15 total
Hardware (Step 13)
S1 - 2 1/2" Screws
x 39 total
sales@outdoorlivingtoday.com
Advertisement
