Advertisement
41.
Take the inside-to-inside measurement between Top Wall Plates and Bottom Wall Plates at
the front, middle, and rear of your shed. These measurement should each be approximately 136 1/2",
but more importantly, if they are not within 1/4" of each other, your walls are not square.
44.
Where Ridge Boards meet, press together and secure with 16 - 1 1/4"
screws per side. We recommend using a clamp to hold the Ridge Boards
together flush while screwing. Stagger screw position vertically on Ridge
Board to create a stronger connection. Complete both sides, Important: if there
is a gap between Ridge Boards, try pushing side walls closer together from
outside. Walls should be 136 1/2" apart at top from inside of wall plate to wall
plate as per Step 41.
Toll Free 1-888-658-1658
136 1/2"
136 1/2"
136 1/2"
www.outdoorlivingtoday.com
Page 26
Advice: It may be helpful
to use a clamp to help hold
Ridge Boards together
flush while screwing.
Hardware (Steps 44)
S2 - 1 1/4" Screws
x 32 total
sales@outdoorlivingtoday.com
Advertisement
