Advertisement
Important: If walls are not lining
up and appear higher or lower than
each other, please check the level
of your floor. You may need to
make slight adjustments before
proceeding.
26.
When all walls are attached
together, check alignment with the
floor. Bottom wall framing should
sit flush with outside of floor joists.
When positioned correctly, fasten
bottom wall plates to floor using
4 - 2 1/2" screws per wall panel
(54 total).
Confirm 32" wide
door opening at bottom.
Angle
screws into perimeter
Floor Joists.
Toll Free 1-888-658-1658
Bottom Wall
Framing
Optional: Caulking seams will
help prevent moisture from
entering your shed. Caulking
is included to complete polygal
Windows
only.
Additional
Caulking may be required.
www.outdoorlivingtoday.com
Page 18
Advice: Prior to fastening walls and installing
rafters, take time to confirm your walls are
level, square and plumb.
Measure diagonal at top and bottom of walls
corner-to-corner. This should be approximately
223 1/2". More importantly, if measurements
are not within 1/4", your walls are not square.
Adjusting now will make it easier to the roof
section later
.
sales@outdoorlivingtoday.com
Advertisement
