Advertisement
C. Rafter Section
Ridge Boards Connectors (3)
Ridge Boards 45 1/2" (2)
Rafters (24)
Important:
Locate all parts necessary to assemble each Rafter Section prior to beginning.
Parts for One Rafter Section (Polygal Side):
12 - 1 1/2" x 3 1/2" x 80 7/8" - Rafters
2 - 3/4" x 9 1/4" x 91" - Ridge Board
2 - 1/2" x 4 1/2" x 91" - Soffits
12 - 3/4" x 3/4" x 48" - Polygal Support Cleats
4 - 3/4" x 3/4" x 38" - Polygal Support Cleats
* Must complete 2 Rafter Sections
Follow Steps 33-49 to Assemble Rafter Sections. Make sure to complete on a flat, level surface.
Metal Ridge Board Connector
Ridge Board 91"
33.
Locate Ridge Boards and attach together
using Metal Ridge Board Connectors and
8 - 3/4" screws evenly spaced on boards per
connector. Place connector approximately 1 1/4" up
from bottom of Ridge Board. Total length when
connected is 182". Complete two Ridge Boards.
Toll Free 1-888-658-1658
Gussets (4)
Ridge Board 45 1/2"
www.outdoorlivingtoday.com
Soffits (4)
Parts for Other Rafter Section (Non-Polygal Side):
12 - 1 1/2" x 3 1/2" x 80 7/8" - Rafters
2 - 3/4" x 9 1/4" x 45 1/2" - Ridge Boards
1 - 3/4" x 9 1/4" x 91" - Ridge Board
2 - 1/2" x 4 1/2" x 68 1/4" - Soffits
Remaining Rafter Pieces:
4 - 3/4" x 80" x 19 3/4" - Gussets
Parts (Steps 33)
Ridge Boards
(3/4" x 9 1/4" x 45 1/2") x 2
(3/4" x 9 1/4" x 91") x 3
Page 22
Ridge Boards 91" (3)
Polygal
Roof Side
Polygal Support Cleats
48" (12)
38" (4)
8 - 3/4" screws
Hardware (Steps 33)
SS2 - 3/4" Screws
x 24 total
Y9 - Metal Ridge
Connector
x3 total
sales@outdoorlivingtoday.com
Advertisement
