Lighting System; Headlight - Benelli TNT 25 Maintenance Manual

Lighting System

Headlight

Disassemble the headlight (see "Frame-Fairing Disassembly")
Headlight Bulb Replacement
●Disassemble the rear housing and remove 4 fixing screws [A]
●Disconnect the headlight bulb connector [A]
●Loosen the headlight bulb fixing circlip [A]
●Remove the bulb from its mounting position after the bulb is
cooled [A]
Warning
When managing the quartz-halogen bulb, do not touch the
glass bulb directly with your hands. A clean cloth must be
used. The dirts on hands or dirty cloth may reduce the
service life of bulb even cause the bulb explosion.
*Note
○Use the alcohol or solvent of soap and water to clean the oil
stains which accidentally remain on the surface of bulb
●Replace the headlight bulb
●Place the bulb at the installation position properly and stably
●Install the fixing circlip in place to make the bulb stable
7-25