Table of Contents
Advertisement
Brake Pads
Disassembling Front Brake Pads
•Disassemble front calipers
•Disassemble the fixed pin of Brake Pads[A].
•Disassemble:
Fixing pin of Brake Pads [A],
Spring plate of Brake Pads [B],
Fixing pin clip of Brake Pads [C]
When pulling out pin A, please press safety spring B
•Disassemble:
Front Brake Pads
Installing Front Brake Pads
•Push the calipers inward as far as possible.
•Install:
The operations should be conducted in reverse order of disassembly.
•Check: brake fluid level [B], if it is lower than the low limit, add
sufficient brake fluid recommended until it reaches the correct level.
•Check: brake handle/pedal operation, if the brake handle/pedal feels
loose and soft, or light and soft, empty the air from the brake circuit.
○Grasp the brake handle/pedal, until Brake Pads is against the
brake disc, so that the brake handle/pedal can function as normal.
Do not ride the motorcycle before you complete the above steps!
Because if you do not complete the above operation, brake may
not work normally when being used for the first time and thus
danger is caused.
Note
Warning
6-45
Advertisement
Table of Contents
Troubleshooting
