Table of Contents
Advertisement
Battery Activation
●Filling Electrolyte
○Make sure that the model [A] marked on the electrolyte bottle
matches with the model [B] of the battery. These models must be the
same.
Storage battery model: YTX7L-BS
Make sure to use the electrolyte of the model same as that
marked on the storage battery, because the volume and density
of used electrolyte are different if the storage battery models
are different. This is to prevent excessive filling the electrolyte
that shorten the life of battery and reduce its performance
Do not tear the aluminum sealing fin [A] of the filling port [B]
before use. Make sure to use the special electrolyte storage
container to guarantee that suitable volume of the electrolyte is
filled
○Place the battery on a horizontal plane
○Check whether there are peeling, crack or hole on the sealing fin
○Disassemble the sealing strip
○The battery is vacuum sealed. If the sealing fin enables the air to
enter into the battery, the first charging time may be longer.
●Remove the electrolyte bottle from the plastic bag
●Remove the strip covers [A] from the container, place them aside
and then use them to seal the battery.
○Do not puncture or open the sealing layer [B] of electrolyte
bottle. Do not attempt to separate the individual liquid storage
chambers.
●Topple the electrolyte bottle and put six sealing grooves in the
filling port of battery. Keep the electrolyte bottle level and push it
down to puncture the sealing of all six liquid storage chambers. As
the sealed liquid storage chambers are inserted into the filling port,
you will see that there will be rising bubbles in the liquid storage
chambers.
○Do not tilt the electrolyte bottle
Warning
Warning
* Note
*Note
*Note
7-8
Advertisement
Table of Contents
Troubleshooting
