Table of Contents
Advertisement
8.2.1
Adjusting rear suspension spring preload
Adjust the spring preload by means of the two ring nuts
(A and B) shown in the figure. Unloose the ring nut (A)
and adjust the preload using the ring nut (B).
Turn clockwise for a stiffer preload.
Turn anticlockwise for a softer preload.Once the
adjustment is over, tighten the ring nut (A).
8.2.2
Adjusting rear suspension rebound
damper hydraulic device
Adjusting of the rebound damper hydraulic device is made
in jerks. Turn the rule (C) clockwise to increase the braking
action, or turn anticlockwise to decrease it.
8.2.3
Adjusting rear suspension compression
damper hydraulic device
Adjusting of the compression damper is made in jerks.
Turn the rule (D) clockwise to increase the braking ac-
tion, or turn anticlockwise to decrease it.
8.2.4
Hydraulic compression braking system at
high-speed back - wheel suspension
Adjusting of the compression damper is made in jerks.
Turn the rule (E) clockwise to increase the braking ac-
tion, or turn anticlockwise to decrease it.
Tornado Naked Tre 1130
Tornado Naked Tre 1130
https://www.motorcycle-manual.com/
95
96
Advertisement
Table of Contents
