Technical Parameters - Benelli TNT 25 Maintenance Manual

Technical Parameters

EFI system
Idle speed
Throttle valve assembly:
Type
Diameter
Negative value of throttle valve
Bypass screw
ECU:
Manufacturer
Type
Avaliable engine rotation speed scope
Fuel pressure (high-pressure pipe):
Fuel pump:
Type
Fuel pump capacity
Fuel injector:
Nozzle style
Resistance:
Throttle valve sensor:
Input power voltage
Output power voltage
Resistance
Manifold absolute pressure sensor / atmosphere sensor
Input power voltage
Output power voltage
Intake air temperature sensor:
Output voltage of ECU
Resistance
Coolant temperature sensor
Output voltage of ECU
Speed sensor:
Input power voltage
Output power voltage
Roll over sensor of motorcycle:
Actuation mode
Actuation angle
Output voltage
Item
1400 ±100 r/min (rpm)
Cylinder type
Φ34 mm
2.7 kPa
—
Delphi
Electronic memory type, equipped with IC ignitor, sealed using
resin
100 -11 200 r/min (rpm)
250 kPa
Built-in friction fuel pump of fuel tank
≥67 mL per 3 seconds (2.3 US oz.)
Finely atomized type,
11.7-12.3Ω at the temperature of 20°C (68°F)
DC 4.75-5.25 V
DC 0.63-3.91 V (the opening of throttle valve is idle speed to
completely open)
4-16Ω
DC 4.75-5.25 V
DC 3.80-4.20 V[standard atmospheric pressure ]
=2.80-2.97 V at the temperature of 20°C (68℉)
2.21 -2.69kΩ at the temperature of 20°C (68℉);
≈0.322 kΩ at the temperature of 80°C (176℉)
≈2.80-2.97 V at the temperature of 20°C (68°F)
DC 4.75 -5.25 V
≈ DC 0.05-0.09 V or DC 4.5-4.9V at the state of opening power
lock or idle state of motorcycle
Magnetic flux detection trigger type
When the side tipping at left and right is greater than 60-70°
The arrow of sensor is upward: 3.55-4.45 V
Angle of inclination of sensor ≥60°-70°: 0.65-1.35V
3-10
Standard